discharge capacity

基本解释

The com-parison between complex and mix of organic expanders by testing the cyclic voltammetry and discharge capacity was discussed in this paper.
介绍了采用测试循环伏安曲线和放电容量的方法来比较复合和混合有机膨胀剂的不同效果。
In addition, the fading rate of discharge capacity at the upper voltage plateau is also increased by the accelerating trend of electrolyte oxidation.
另外电解质的氧化也呈加速趋势，加快了高电位平台放电容量的衰减速度。
The labyrinth weir has the advantage of discharge capacity relative to that of the straight weir.
迷宫堰相较于直线堰，最大的优越性体现在它的泄流能力上。

According to the testing performed to date at the Ohio State University's Center for Automotive Research (CAR) and the very low observed rate of aging, cells built with A123's Nanophosphate EXT are expected to be capable of retaining more than 90 percent of initial capacity after 2, 000 full charge-discharge cycles at 45 degrees Celsius.
ENGADGET: A123 Systems' new lithium ion tech keeps EV batteries cool, your wallet in check

放电容量
However, the lithium manganese oxide doped aluminium has lower discharge capacity and poor cycle property.
掺铝锉锰氧则放电容量较低，且循环性能也较差。
放电比容量

放电容量
Annealing process improved activation property and discharge capacity.
快淬热处理改善了合金的活化性能，提高了最大放电容量。
水利工程
泄流能力
The discharge capacity of a pressure spillway tunnel is a key problem involving its scale and sizes,and it also is a hydraulic issue which needs to be solved in design.
有压泄水洞的泄流能力是一个涉及其规模、尺寸的关键问题,是设计中必须解决的水力学问题。
过流能力
All these works are related to the questions of the computation of discharge capacity and the determination of the flood levels.
上述工程均涉及到复式断面河道的过流能力计算以及洪水位确定问题。
过水能力

过流能力
Once the discharge capacity decreased, the flow which can be discharged reduced either. This results in drainage hindrance and submerging of the upstream district, as well as the subgrade soaking for a long time.
由于水库修建之后,在水库回水区影响范围内的涵洞出口水位可能会抬高,从而有可能造成涵洞内水流过流状态的变化,一旦涵洞过流能力减小,排水不畅,就会导致上游地区的淹没,还可能造成路基长时间浸泡,承载能力下降,从而跨塌,后果不堪设想。
土木建筑工程
通水能力
The results indicated that the maximum discharge capacity, the terminal velocity and the largest permissible fullness ratio of110mm plastic stack were 6.255L/s, 4.201m/s,and 0.18 respectively when there was only stack vent.
试验结果表明：①仅设伸顶通气管条件下，φ110塑料排水立管最大通水能力为6.255L／s，立管终限流速为4.201m／s，其最大允许充水率α为0.18。
排泄能力